I maxed the 12" front supports out and made the rear supports slightly lower to keep a slight rake in the bunks. I used 12" supports which raised the boat up some to give added room for the fenders. I also replaced all the bunk boards and bunk hardware with longer bunk supports. To clarify, the fenders came with predrilled holes for whatever application they were originaly intended for, so I drilled some that made them sit closer to the tire than what they came with. The fenders seem to work at this point, but I did drill new holes and actually lowered the fender down some so there is not as much space between the tire and top of the fender. plywood and covered them with standard bunk carpet. ![]() ![]() I made the skirts out of 15/32 (1/2") p.t. I got them on after adding the wheel spacers and longer wheel studs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |